Welcome to UK-Stairlift
Acorn Superglide Repair Article
This is a selection made from among articles on Acorn Superglide Repair. For a permanent link to this article, or to bookmark it for future reading, click here.
Stair Lift Installation
from:A stair lift is a device that is used to lift a person up the
stairs, much like an escalator. These devices generally use a
rail or track system that is attached to the stairs and spans
the complete distance of the stairs. A chair or small platform
is attached to the track and is sent up and down the track.
These devices are very safe and reliable, but there are some
safety concerns that should be addressed both when using these
devices and when installing them.
It is imperative that you both read and understand the
manufacturer's installation instructions before you begin your
initial setup. On standard non-winding stairs the installation
can usually be done in a few hours by a single individual, but
before you do anything carefully read the instructions. One of
the most important steps will be securing the track to the
stairs. Follow the manufacturer's instructions and use the
included hardware to secure the track to the stairs. Usually the
track comes in sections that are made to slide together and are
secured with bolts.
Most of the actual installation can be done with standard
household tools. Usually a set of Allen wrenches (often
included), a set of Phillips heads screwdrivers, a 3/8 inch
socket set, a power drill, a tape measure, and a level will be
all that is required to set up the stair lift. Some models do
require a tool called a torque wrench, which may sound
complicated or foreign, but it really isn't. A torque wrench is
a wrench that has a gauge or dial attached to it that lets you
tighten a bolt to a specific tension. All you need to do is very
lightly tighten the bolt while keeping an eye on the gauge that
is attached to the wrench. If you are tightening the bolt to 18
ft/lbs then just apply constant pressure until the gauge reads
about 18. Torque wrenches can be found at most hardware stores
as well as at auto parts stores.
Once the track is down it will be time to put the chair onto the
track. Usually the chair is attached to a short piece of track
that is only a foot or two in length. This short piece of track
is temporarily attached to the track at the top of the stairs. A
bolt holds the chair in place on this temporary track. Once the
bolt is removed the chair will slide down onto the actual stair
lift track. It is important that either you or your assistant
apply pressure to the chair when you remove the retaining bolt.
Once the bolt is removed the chair will slide freely so make
sure you hold the chair in place until your hands are out of the
way, then let is slowly slide down onto the track.
A stair lift that has been installed properly will provide many
years of dependable and safe service. It can generally be done
by one person. If after reading the installation instructions
you are hesitant at all about the set up, call up your
distributor and they can either help you with the instructions
or recommend a company that will install it for you at a good
rate.
About the author:
Brad Brubaker is a technical writer for www.a1-medical-supplies.net. a1-medical-supplies.net has some of the best deals on new and used stair lifts. To save thousands of dollars visit their site or call one of their highly trained specialists.
Use Our Free Service Now!
If you are looking for a new stair lift, a reconditioned | second hand stair lift or a rental stair lift, we can help.
Fill in your details below and we will contact the leading Stairlift Comapnies that operate in YOUR AREA on your behalf. Once you have been contacted, you can then decide on the best deal that has been made available to you.
Let us do all of the running around for you.
Note: This service is only available to UK residents.